Warehouses Closed November 28 & 29

Thread Catcher

Thread Catcher

Written by: 
Christine Weld

cover-photo-resized

Do all quilters have little piles of thread all over the house? I know I do! There are some by my sewing table, some on the couch arm, and, unfortunately, way too many wrapped around my vacuum cleaner!

I made this easily portable thread catcher to use as a little nest for all the bits of thread. I keep it next to my sewing machine when I'm working there and then bring it with me when I'm doing handwork. It keeps all those little pieces of thread nice and tidy!

This project finishes at 6" square.

 

8cb62-title_ingredients

1 10" square of fabric (you can use a single square from a Layer Cake or a piece of a fat quarter)

One 5 3/4"" piece of Timtex or heavy weight interfacing

One 5 3/4" piece of fusible web

Two 1 3/4" squares of fusible web

Four 1 1/2" by 3/4" pieces of fusible web

One  5 1/2" square of batting

 

img_9139

 

96b91-title_instructions

Fuse the 5 3/4" piece of fusible web to the Timtex. Center the piece of Timtex on the fabric square. You should have 2 1/8 inches of fabric on each side of the Timtex. Press, fusing the fabric, webbing, and Timtex.

img_9142

Fold each corner so that the corner of the fabric is about 1/8" away from the corner of the Timtex.

img_9164

Fold the corner of the fabric again so the fabric overlaps the Timtex. An equal bit of fabric should hang over each edge. The bottom of the fold should be about 1/8" from the corner of the Timtex.

 

img_9167  img_9168

Cut the two 1 3/4" squares of fusible web diagonally so you have four triangles.

img_9169

Fuse the triangles to the corners, on top of the folded fabric.

img_9172

Take the four 1 1/2" by 3/4" pieces of fusible web and place them against the raw edge of the fabric.

img_9171

Remove the paper from the fusible web. Fold the fabric over. The raw edge should be about 1/8" from the edge of the Timtex. Press to fuse.

img_9173

Remove the fusible web from the corners. Fold the fabric over so that the edges of the folded fabric meet. Press well.

img_9174

Ease the piece of batting underneath the fabric. When the batting becomes worn out, remove and place a new square 5 1/2" square of batting.

img_9177

 

4b2da-title_yield

This thread catcher finishes at about 6" square.

img_9179

Enjoy using your new thread catcher! May your tables, rugs and furniture be free of thread piles!

Christine Weld
thequarterinch.blogspot.com

Save